Main Page | See live article | Alphabetical index

Envelope detector

An envelope detector is a device which is used to demodulate AM signals. The original message is decoded from the envelope of the modulated signal.

Table of contents
1 Definition of the Envelope
2 Diode Detector
3 Precision detector
4 Drawbacks

Definition of the Envelope

Any AM or FM signal can be written in the following form
x(t) = R(t)cos(ωt+φ(t))

In the case of AM, &phi(t) is constant and can be ignored, so all the information in the signal is in R(t), which is called the envelope of the signal. Given that an AM signal is given by the equation with m(t) representing the original audio frequency message,
x(t) = (C + m(t))cos(ωt)
R(t) is then equal to (C + m(t). So, if the envelope of the AM signal can be extracted, the original message can be recovered.

Diode Detector

The simplest form of envelope detector is the diode detector. To construct a diode detector, simply connect a diode between the input and output of a circuit, and connect a resistor and capacitor in parallel from the output of the circuit to the ground. If the resistor and capacitor are correctly chosen, the output of this circuit should approximate a voltage-shifted version of the original signal. A simple filter can then be applied to filter out the DC component.

Precision detector

An envelope detector can also be constructed to use a precision rectifier feeding into a low-pass filter.

Drawbacks

The envelope detector has several drawbacks Most of these drawbacks are relatively minor and are usually acceptable tradeoffs for the simplicity and low-cost of using an envelope detector.